In order to improve and stabilize the quality of the products, it’s necessary to continuously monitor the optimal load. Excessive load generates not only defective products, but damage of the machine and the dies, and becomes a cause of deterioration in the cost performance due to waste of time and materials. In order to prevent such problems, the load monitor outputs a stop signal to the press machine, when the load exceeds the monitoring range that has been set in advance.
PTM series load monitor is the most advanced load monitoring system offered by the company. Utilizing smart-sampling alarm control and statistical process control, this system helps to protect machines and quality control.
Features
- Multiple monitoring and alarming functions(overload, rolling average-value comparison, absolute-value comparison, reserve load)
- Simultaneous peak load display for each channel (available to support reserve load)
- Total peak load display
- Load waveform analysis
- SPC chart display function incorporated (statistical process management)
- Peak load history display
- Display slide position and load by Inputting resolver angle
- Easy touch-panel operation
- Monitor eccentric load deviation (left/right) by setting %
Display load history and analysis results by an easy operation
Ethernet support (optional) enables data sharing between sections and data confirmation from remote locations
If network is built,unified management of data acquired is possible. Sharing data measured between related sections enables monitoring data to be extracted immediately.
Specifications
Electrical Specifications |
Power Input Range |
90~240 VAC |
---|---|---|
Current Consumption |
3.125A | |
Number of Channels | 2ch=(PTM-2300) / 4ch(PTM-4500) | |
A/D Conversion Method | 16 bit | |
Environmental Specifications | Operating Temperature | 0℃ to 50℃(32°F to 122°F) |
Input Specifications | Type of Input | Strain Gauge(175ohm、350ohm、700ohm) |
Display Resolution | Up to 0.1% of Full Scale | |
Overall Unit Accuracy |
Within 1% of Full Scale |
|
A/D Sample Rate | 333μsec. | |
Supports maximum SPM | 200(Resolver) | |
Output Specifications | Output contact | 1A contact capacity : 240VAC 10A |